Tandberg-data FS-1610 User Manual download pdf (Page 36)

Tandberg Data System Management

_____________________________________________________________

5-4 Tandberg Viking FS-1600 Series NAS Hardware User Manual

Notes

Further RAID configuration can be performed using web-based RAID manager after

the OS is recovered using a web-browser and point to the following URL:

http://<your NAS appliance IP address>:81

The default user name is “admin”. The default password is “0000”.

6. Exit from the BIOS by pressing F10 key and system will restarted.

For further detail on configuring RAID and Volume sets using the controller

BIOS as well as using the web-based RAID manager, see ARECA ARC-

1160/ARC-1261ML Serial-ATA RAID Controller User Manual.

5.2.2. Changing RAID Level and Capacity Size

The RAID BIOS and web-based RAID manager are also used to change the

RAID level as well as the capacity size of the configured volumes. After the

creation of the System and the Data Volume, further alteration to their RAID

level and capacity is allowed via these means.

1. Access either the RAID BIOS or the web-based RAID manager, see

details in section 5.2.1.

Notes

See the ARECA ARC-1160/ARC-1261ML Serial-ATA RAID Controller User Manual

for further details.

2. The ARC-1160/ARC-1261ML Serial-ATA RAID controller will

perform the configuration change once confirmed. Depending on the

extend of change the process may take a few minutes to several

hours to complete. The appliance must be rebooted for the change

to take effect.

5.3. System Recovery

The Image Restoration lets you restore the system image factory default

settings.

Notes

Using the Image Restoration utility removes all data on the System Volume. Make

sure that you back up important files before starting the restoration process. Image

restoration can only be performed after System Volume has been created.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

No comments

Tandberg-data FS-1610 User Manual Page 36